Step 1: Prepare Surface and Decal
Use a damp cloth to clean the surface of any residue or dust particles. This is important to ensure vinyl adhesion. If the surface has recently been painted, you need to allow the paint to cure for at least 2 weeks before installing the decal. Unroll decal and lay on flat hard surface. Use squeegee or credit card on both sides of the decal to smooth out any wrinkles. If the decal will not lay flat, you can weigh it down with books.
Step: 2 Position Decal on Surface
Use painter’s tape or masking tape on the corners of the decal. Make sure the decal is placed in the desired position. Use a level or tape measure to make sure the decal is straight. When the decal is level and in correct position use one long strip of tape and place it down the middle (shortest distance) of the decal to create a hinge.
Step: 3 Transfer Decal to Surface
With the decal taped to the surface, detach one side of the decal. Fold the decal over the center line and carefully peel back the backing paper then cut away the backing paper. Take your time and do not rush the process. Using a squeegee or credit card in a smooth sweeping motion moving from the center out push the decal against the surface. Remember to work from the center outwards to avoid any bubbles. After finished with one side, remove the center tape line and repeat the process with the other side. If you are applying to a rough surface, you may need to wrap the squeegee in a soft cloth for better application.
Weather: In extreme weather conditions vinyl might not apply as well on exterior walls or in places like a garage or tool shed. Vinyl applies best in temperatures between 60-80 degrees. If the surface is too cold, vinyl will not stick well and may cause the vinyl to tear. If the surface feels cold you may want to warm up first. If the surface is too hot or in direct sunlight the decal may be too sticky and become difficult to install or ruin the decal.
Wall Texture: Decals may not stick well to highly textured surfaces. To achieve the best adhesion possible on a textured surface, use your fingers or a soft cloth to very gently run the decal into the grooves of your texture.